C H A P T E R 13 1-Port Oc-12 Packet Over Sonet Line Card Configuration - Cisco 10000 Series Configuration Manual

Default Values
Checking Hardware and Software Compatibility
The PRE installed in the Cisco 10000 series router chassis must support the Cisco IOS software running
on the router. Use the show version command to check the PRE version installed.
To see if a feature is supported by a Cisco IOS release, to locate the software document for that feature,
or to check the minimum software requirements of Cisco IOS software with the hardware installed on
your router, Cisco maintains the Software Advisor tool on Cisco.com at
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl
This tool does not verify whether line cards within a system are compatible, but does provide the
minimum Cisco IOS requirements for individual hardware line cards, modules, or options.
You must be a registered user on Cisco.com to access this tool.
Default Values
Table 13-2
the command used for modifying a default value and indicates whether a value needs to be the same (or
opposite) on the remote end of the connection.
Table 13-2
Command Name
bandwidth
clock source
crc
encapsulation
keepalive
mtu (maximum
transmission unit)
pos framing
pos scramble-atm
pos flag (SONET
overhead)
Cisco 10000 Series Router Line Card Configuaration Guide
13-2
lists default values for the 1-Port OC-12 Packet over SONET line card. This table includes
1-Port OC-12 Packet over SONET Line Card Defaults
Default
Setting
622000
line
32
HDLC
no keepalive
4470
SONET
No scrambling
c2—0xcf
j0—0x01
s1s0—0
Chapter 13 1-Port OC-12 Packet over SONET Line Card Configuration
Command Syntax
bandwidth kilobits
clock source [line | internal]
crc [16 | 32]
encapsulation [hdlc | ppp]
[no] keepalive period
mtu size
pos framing [sonet | sdh]
[no] pos scramble-atm
pos flag [c2 | j0 | s1s0] value
Remote Side Setting
Same.
At least one side
must be set to
internal.
Same.
Same.
Same.
Same.
Same.
Same.
Same.
OL-8834-04