Completing Initial System Configuration - Cisco ASR 5000 Series Installation Manual

Applying Power and Verifying the Installation

Completing Initial System Configuration

After power is applied to the chassis and the ASR 5000 has successfully booted, the command line interface (CLI)
appears on a terminal connected to the Console port of the SPIO.
The initial configuration requires completing the following tasks via the CLI:
 Configuring the system for remote access
 Configuring the management interface with a second IP Address (optional)
 Configuring system timing
 Enabling CLI timestamping
 Configuring system administrative users
 Configuring TACACS+ for system administrative users (optional)
 Configuring a chassis key
 Configuring virtual MAC addresses
 Configuring packet processing and line card availability
 Configuring line card and SPIO port redundancy
 Configuring ASR 5000 link aggregation (optional)
 Configuring ORBEM and the Web Element Manager (optional)
 Configuring SNMP support and trap generation
The Getting Started, Configuring System Settings and Configuring Management Settings chapters of the System
Administration Guide provide detailed procedures for completing the above tasks.
Completing Initial System Configuration ▀
ASR 5000 Installation Guide ▄
185