Mac Protocol Selection Command - Cisco 10000 Series Configuration Manual

MAC Protocol Selection Command

If necessary, modify the 1-Port OC-48/STM-16 Packet over SONET line card configuration or the
Step 5
configuration of the remote device to ensure that they use the same settings, where appropriate. For more
information, refer to the Remote Side Setting column in
Add any other configuration commands required to enable routing protocols and adjust the interface
Step 6
characteristics.
Enter the no shutdown command to enable the interface. For example:
Step 7
Router(config-if)# no shutdown
When you have included all of the configuration commands to complete the configuration, enter Ctrl-Z
Step 8
to exit configuration mode.
Write the new configuration to memory.
Step 9
Router# copy running-config startup-config
The system displays an OK message when the configuration has been stored.
After you have completed the configuration, you can verify that it is correct using the show interface
pos slot/subslot/port command.
MAC Protocol Selection Command
You must specify the MAC protocol that the 1-Port OC-48/STM-16 Packet over SONET line card will
use before you configure the interface, by using the following command:
hw-module slot slot [pos]
Where slot is 1 to 8.
The following example shows how you specify the Packet over SONET MAC protocol for a card in slot
2:
Router(config)# hw-module slot 2 pos
Interface Configuration Mode Command
To configure an interface, you must specify an interface configuration mode by using the following
command:
interface [pos | sdcc] slot/subslot/port
Where slot is 1 to 8, subslot is 0, and port is 0.
The following example shows how you specify Packet over SONET interface configuration mode for a
card in slot 2:
Router(config)# interface pos 2/0/0
Router(config-if)#
Cisco 10000 Series Router Line Card Configuaration Guide
14-4
Chapter 14 1-Port OC-48/STM-16 Packet over SONET Line Card Configuration
Table 14-2.
OL-8834-04