Checking Hardware And Software Compatibility - Cisco 10000 Series Configuration Manual

Default Values

Checking Hardware and Software Compatibility

The PRE installed in the Cisco 10000 series router chassis must support the Cisco IOS software running
on the router. Use the show version command to check the PRE version installed.
To see if a feature is supported by a Cisco IOS release, to locate the software document for that feature,
or to check the minimum software requirements of Cisco IOS software with the hardware installed on
your router, Cisco maintains the Software Advisor tool on Cisco.com at
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl
This tool does not verify whether line cards within a system are compatible, but does provide the
minimum Cisco IOS requirements for individual hardware line cards, modules, or options.
You must be a registered user on Cisco.com to access this tool.
Default Values
Table 10-2
includes the command used for modifying a default value and indicates if a value needs to be the same
(or opposite) on the remote end of the connection.
Table 10-2 1-Port Gigabit Ethernet Half-Height Line Card Defaults
Command Name
auto-negotiation
mtu (maximum
transmission unit)
Interface Syntax
To specify an interface number in a configuration command, use the syntax in
interfaces on the 1-Port Gigabit Ethernet Half-Height line card.
Table 10-3 1-Port Gigabit Ethernet Half-Height Interface Syntax
Slot
1 to 8/
The following example shows the syntax for configuring a 1-Port Gigabit Ethernet Half-Height line card
in slot 1:
Router(config)# interface GigabitEthernet 1/0/0
Router(config-if)#
Cisco 10000 Series Router Line Card Configuaration Guide
10-2
lists default values for the1-Port Gigabit Ethernet Half-Height line card. This table also
Default Setting
Enabled
• 1500 to 4470
(full-height)
1500 to 9180
•
(half-height)
Subslot Port
0 or 1/ 0
Chapter 10 1-Port Gigabit Ethernet Half-Height Line Card Configuration
Remote
Side
Command Syntax Setting
Same
[no] negotiation auto
Same
mtu size
Table 10-3 to identify
OL-8834-04