Naming Convention - Cisco 10000 Series Configuration Manual

Chapter 15 8-Port Unchannelized E3/T3 Line Card Configuration
Table 15-2
Command Name
loopback
mdl
scramble
shutdown
E3 Interface Configuration Mode
bert
description
encapsulation
dsu bandwidth
dsu mode
fallback-clocking off
idle character
loopback
scramble
shutdown

Naming Convention

The Cisco 10000 series router line cards use the extended slot naming convention to identify the line
card slot, subslot, and port in commands. This convention uses the following format:
slot/subslot/port
Where:
•
•
•
Interface Syntax
The following tables contain the line card syntax to configure 8-Port Unchannelized E3/T3 line card
interfaces for the Cisco 10008 router and Cisco 10005 router chassis.
OL-8834-04
8-Port Unchannelized E3/T3 Line Card Parameters (continued)
Default Value
no loopback
no mdl
no scramble
no shutdown
no bert
—
hdlc
34,368 kbps
cisco
flags (0x7e)
no loopback local
network line
no scrambling
no shutdown
slot is the slot number of the installed the line card
subslot is the subslot number of the line card (the subslot number for all full-height line cards is
always 0)
port is the number of the line card port
Command Syntax
[no] loopback network [line | payload]
[no] loopback [local | remote]
[no] mdl {transmit {idle-signal | path |
test-signal} | string {eic | fic |
generator | lic | pfi | port | unit}
<string>}
[no] scramble
shutdown
[no] bert pattern pattern interval time
[unframed]
description string
encapsulation [hdlc | ppp |frame-relay]
[no] dsu bandwidth bandwidth
[no] dsu mode [cisco | kentrox]
fallback-clocking on | off
idle character [flags | marks]
[no] loopback network [line | payload]
[no] loopback [local | remote]
[no] scramble
shutdown
Cisco 10000 Series Router Line Card Configuaration Guide
Default Values
Remote
CSU/DSU
Setting
No
Same
Same
—
Same
—
Same
Same
Same
Same
Same
No
Same
—
15-3