Global Configuration Commands - Cisco 10000 Series Configuration Manual

Command Descriptions
The Following example shows the output displayed on the system console for the serial interface
configuration on router chassis slot 1, subslot 0, port 0, and channel-group 0 when this command
executes:
Router# show interfaces serial 1/0/0:0
Serial1/0/0:0 is down, line protocol is down
Hardware is Channelized E1T1 controller
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:00:18
Queueing strategy: PXF First-In-First-Out
Output queue 0/32, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions alarm present
Timeslot(s) Used: 1, subrate: 64Kb/s, transmit delay is 0 flags
non-inverted data
Router#
This command does not have a no form. You must specify at least one channel group when you use this
command. You can also specify a subcommand from a number of associated subcommands (see
Table 5-2 on page 5-2

Global Configuration Commands

The line card Cisco IOS global configuration commands are:
•
•
•
•
You use the configure terminal command to enter the global mode from the privileged EXEC mode:
Example:
Router> enable
Password: (you enter your administrative password)
Router# config terminal
Enter Configuration commands, one per line. End with CNTRL/Z.
Router(config)#
When your prompt changes to
Cisco 10000 Series Router Line Card Configuaration Guide
5-14
and Table 5-4 on page
card
hw-module (shutdown)
controller
interface
Chapter 5
5-4).
you are in the global configuration mode.
Router(config)#
24-Port Channelized E1/T1 Line Card Configuration
OL-8834-04