Default Values; Line Card Vc Limitations - Cisco 10000 Series Configuration Manual

Default Values

Checking Hardware and Software Compatibility
The PRE installed in the Cisco 10000 series router chassis must support the Cisco IOS software running
on the router. Use the show version command to check the PRE version installed.
To see if a feature is supported by a Cisco IOS release, to locate the software document for that feature,
or to check the minimum software requirements of Cisco IOS software with the hardware installed on
your router, Cisco maintains the Software Advisor tool on Cisco.com at
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl
This tool does not verify whether line cards within a system are compatible, but does provide the
minimum Cisco IOS requirements for individual hardware line cards, modules, or options.
You must be a registered user on Cisco.com to access this tool.
Default Values
Table 3-2
the command used to modify a default value, and provides information about values to set on the remote
end of the connection.
Table 3-2 1-Port OC-12 ATM Line Card Defaults
Command Name
mtu (maximum transmission
unit)
atm clock internal
loopback
pvc encapsulation

Line Card VC Limitations

The Cisco 10000 series router supports four ATM service categories for virtual circuits (VCs):
•
•
•
•
The segmentation and reassembly (SAR) mechanism configures priority and additional traffic
management parameters for the various ATM service categories.
SAR sets for the service categories.
Table 3-3
Parameter
Priority
Cisco 10000 Series Router Line Card Configuaration Guide
3-2
lists default configuration values for the 1-Port OC-12 ATM line card. This table also includes
Default Setting
9180 bytes
no atm clock internal
loopback none
aal5snap
Constant Bit Rate (CBR)
Variable Bit Rate-non-real-time (VBR-nrt)
Unspecified Bit Rate (UBR) with a peak cell rate (PCR), referred to as shaped UBR
UBR without a PCR, referred to as unshaped UBR
ATM Service Categories
CBR
0
Chapter 3
Command Syntax
[no] mtu bytes
[no] atm clock internal
[no] loopback [line | diagnostic {parallel |
path | serial}]
encapsulation [aal5snap | aal5mux ip]
VBR-rt VBR-nrt
1 2
1-Port OC-12 ATM Line Card Configuration
Remote Side
Setting
same
opposite
—
same
Table 3-3 lists the priority levels the
Shaped UBR Unshaped UBR
3 None
OL-8834-04