Cisco 10000 Series Configuration Manual page 299

Chapter 15 8-Port Unchannelized E3/T3 Line Card Configuration
–
–
–
–
–
–
–
The default is no mdl message.
Use the no form of the command to remove an MDL message.
Examples of configuring MDL messages are:
Enable the MDL path message transmission.
•
Router(config-controller)# mdl transmit path
Enable the MDL idle signal message transmission.
•
Router(config-controller)# mdl transmit idle-signal
Enable the MDL test signal message transmission.
•
Router(config-controller)# mdl transmit test-signal
Enter the equipment identification code.
•
Router(config-controller)# mdl string eic router A
Enter the location identification code.
•
Router(config-controller)# mdl string lic test network
Enter the frame identification code.
•
Router(config-controller)# mdl string fic building b
• Enter the unit identification code.
Router(config-controller)# mdl string unit abc
• Enter the facility identification code.
Router(config-controller)# mdl string pfi string
Enter the port number to send in the MDL idle signal message.
•
Router(config-controller)# mdl string port string
Enter the generator number to send in the MDL test signal message.
•
Router(config-controller)# mdl string generator string
OL-8834-04
eic is the equipment identification code (up to 10 characters).
lic is the location identification code (up to 11 characters).
fic is the frame identification code (up to 10 characters).
unit is the unit identification code (up to 6 characters).
pfi is the facility identification code to include in the MDL path message
(up to 38 characters).
port is the equipment port (which initiates the idle signal) to include in the MDL idle signal
message (up to 38 characters).
generator is the generator number to include in the MDL test signal message (up to 38
characters).
Cisco 10000 Series Router Line Card Configuaration Guide
Interface Configuration Commands
15-15