Cisco 10000 Series Configuration Manual page 115

Chapter 4 4-Port Channelized T3 Half-Height Line Card Configuration
7
7
8
8
Example 4-3
information for a particular line card.
Example 4-3
Router# show redundancy linecard subslot 8/1
Redundant LC Group Number: 0
LC Slot: 8
LC Subslot: 1
Redundant LC Name: 8/1
Redundant LC Mode: Primary
Redundant LC Role: Standby
Redundant LC My State: Stdby Hot
Redundant LC Peer State: -
Router# show redundancy linecard subslot 8/0
Redundant LC Group Number: 0
LC Slot: 8
LC Subslot: 0
Redundant LC Name: 8/0
Redundant LC Mode: Secondary
Redundant LC Role: Active
Redundant LC My State: Active
Redundant LC Peer State: Stdby Hot
Example 4-4
information for a specific line card group, which in this example is group 0. Note that the show
redundancy linecard group command displays only the static line card configuration information. For
example, it shows the line card mode (primary or secondary) but not the line card role, which changes
in a switchover. The line card in slot 8, subslot 1, is primary even though it currently has the standby role.
Because there is only one line card group in the sample configuration, the show redundancy linecard
group all command would display the same output as shown in
Example 4-4
Router# show redundancy linecard group 0
Group Identifier: 0
NON-revertive
Group Redundancy Type: Y_CABLE
Group Redundancy Class: 1:1
Group Redundancy Configuration Type: LINECARD GROUP
Primary: Slot 8
Secondary: Slot 8
The show redundancy linecard history command and the show redundancy linecard sub-block
command provide information that can be helpful to Cisco technical support personnel when they are
assisting you in troubleshooting a redundancy problem. The output in
a line card switchover.
OL-8834-04
0 None Init
1 None Init
0 0 Active
1 0 Stdby Hot
shows output from the show redundancy linecard subslot command. It displays
show redundancy linecard subslot Command Output
shows output from the show redundancy linecard group command. It shows line card
show redundancy linecard group Command Output
Subslot 1
Subslot 0
- None None
- None None
Stdby Hot 8 1
- 8 0
Cisco 10000 Series Router Line Card Configuaration Guide
High Availability Using Line Card Redundancy
None None
None None
Active Secondary
Standby Primary
Example 4-4.
Example 4-5 was collected after
4-27