Figure 11: Attaching The Brackets To The Chassis; Figure 12: Installing The Cage Nuts - Mellanox Technologies SN2100 Hardware User Manual

Rev 1.6
Install 8 cage nuts in the desired 1U slots of the rack: 4 cage nuts in the non-extractable side (in
Step 4.
the top and bottom holes only) and 4 cage nuts in the extractable side.
While your installation partner is supporting the system's weight, perform the following steps:
Mount the system into the rack enclosure, and attach the brackets installed on the system to the
Step 5.
rack's posts. Secure the brackets to the rack's posts by inserting four M6 screws in the desig-
nated cage nuts, as described in
20 Mellanox Technologies

Figure 11: Attaching the Brackets to the Chassis

Figure 12: Installing the Cage Nuts

While each rack U (unit) consists of three holes, the cage nut should be installed verti-
cally with its ears engaging the top and bottom holes only.
Figure 13. Do not tighten the screws yet.
Installation