Figure 51: Fan Module Latches - Mellanox Technologies SN2100 Hardware User Manual

Installation
Grasping the handle with your right hand, push the latch release with your thumb while pulling
Step 1.
the handle outward. As the fan unit unseats, the fan unit status LEDs will turn off.
Remove the fan unit.
Step 2.
 To insert a fan unit:
Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
Step 1.
Insert the fan unit by sliding it into the opening until slight resistance is felt. Continue pressing
Step 2.
the fan unit until it seats completely.
The green Fan Status LED should light. If not, extract the fan unit and reinsert it. After
two unsuccessful attempts to install the fan unit, power off the
ing any system debug.

Figure 51: Fan Module Latches

system
before attempt-
Mellanox Technologies
Rev 1.6
49