Figure 21: Sliding The Switch Into The Rack; Figure 22: Pulling The Unit Outwards - Mellanox Technologies SN2100 Hardware User Manual

Rev 1.6
When fully inserted, fix the switch by closing the remaining 2 screws in the middle and tighten-
Step 7.
ing the 8 screws inserted in Step 2 with a torque of 4.5±0.5 Nm.
2.5.2.1 Removing the System from the Rack
 To remove a unit from the rack:
Turn off the system and disconnect it from peripherals and from the electrical outlet.
Step 1.
Unscrew the two M6 screws securing the front of the inner rails' ears to the outer rails and to
Step 2.
the rack.
Pull the unit out until braking is felt. For safety purposes, the locking mechanism will not allow
Step 3.
a complete removal of the unit at this stage.
26 Mellanox Technologies

Figure 21: Sliding the Switch into the Rack

Figure 22: Pulling the Unit Outwards

Installation