Configuring Network Attributes Using Cumulus Linux - Mellanox Technologies SN2100 Hardware User Manual

Rev 1.6
Disable Dynamic Host Configuration Protocol (DHCP)
DHCP is used for automatic retrieval of management IP addresses.
If a user connects through SSH, runs the wizard and turns off DHCP, the connection is
immediately terminated, as the management interface loses its IP address.
<localhost># ssh admin@<ip-address>
Mellanox MLNX-OS Switch Management
Password:
Mellanox Switch
Mellanox configuration wizard
Do you want to use the wizard for initial configuration?
yes
Step 1: Hostname? [my-switch]
Step 2: Use DHCP on mgmt0 interface? [yes] no
<localhost>#
In such case the serial connection should be used.
2.8.1.2 Remote Connection with MLNX-OS
Once the network attributes are set, you can access the CLI via SSH or the WebUI via HTTP/
HTTPs.
 To access the CLI, perform the following steps:
Set up an Ethernet connection between the system and a local network machine using a stan-
Step 1.
dard RJ45 connector.
Start a remote secured shell (SSH) using the command: "ssh -l <username> <IP_address>",
Step 2.
# ssh -l <username> <ip_address>
Mellanox MLNX-OS Switch Management
Password:
Login as admin (default username is admin, password admin).
Step 3.
Once you get the CLI prompt, you are ready to use the system.
Step 4.
For additional information about MLNX-OS, refer to MLNX-OS User Manual located on Mella-
nox support web.
2.8.2

Configuring Network Attributes Using Cumulus Linux

For Cumulus Linux initial configuration instructions, see
Cumulus Linux Quick Start
2.8.2.1 Remote Connection with Cumulus Linux
Cumulus Linux uses the OpenSSH package to provide SSH functionality. To securely access a
Cumulus Linux switch remotely, please follow the instructions on the
page in the Cumulus Linux User
46 Mellanox Technologies
Guide.
Guide.
Configuring Cumulus Linux
SSH for Remote Access
Installation
on the