Figure 27: Installing The Cage Nuts; Figure 28: Attaching The Rails To The Rack; Figure 29: Sliding The Blades In The Rails - Mellanox Technologies SN2100 Hardware User Manual

Rev 1.6
While your installation partner is supporting the system's weight, perform steps 3, 4 and 5:
On the rear side of the cabinet, install the two blades (B) in the selected rack unit, using four
Step 3.
M6 screws (C). Do not tighten the screws yet. See
Slide the two blades into the left and right rails, and adjust them to fit your rack's depth. Use
Step 4.
four M6 screws (D) to fix the blades into the rack. Do not tighten the screws yet. See
Secure the system in the rack by tightening the 8 screws inserted in Step 3 and Step 4 with a
Step 5.
torque of 4.5±0.5 Nm.
30 Mellanox Technologies

Figure 27: Installing the Cage Nuts

Figure 28: Attaching the Rails to the Rack

Figure 29: Sliding the Blades in the Rails

Figure 28.
Installation
Figure 29.