Figure 38: Attaching The Frame To The Rack; Figure 39: Sliding The System's Blades In The Rails - Mellanox Technologies SN2100 Hardware User Manual

Rev 1.6
Remove the blank cover from the selected slot in the frame, and mount the system by sliding its
Step 8.
mounting blades into the frame. Repeat this step to install an additional system in the other side
of the frame, if needed.
Tighten the capture nuts to secure the system in the frame. The recommended torque on the
Step 9.
right screw is 3.0-3.36 Nm while on the left screw recommended torque is 0.89-0.98 Nm.
36 Mellanox Technologies

Figure 38: Attaching the Frame to the Rack

Do not remove both of the blank covers at the same time. When no system is installed,
at least one of them should be present to support the frame's partition.

Figure 39: Sliding the System's Blades in the Rails

Installation