Dodge dakota 2002 Service Manual page 1463

9 - 214 ENGINE - 5.7L
REAR MOUNT (Continued)
(3) Lower the transmission so the transmission
mount rests on the crossmember, and the studs of
the transmission mount are aligned in the slots in
the crossmember.
(4) Install the nuts onto the transmission mount
studs through the crossmember access slot.
(5) Torque the nuts to 54N·m (40 ft. lbs.).
LUBRICATION
DESCRIPTION
The lubrication system (Fig. 25) is a full flow fil-
tration pressure feed type.
DIAGNOSIS AND TESTING
DIAGNOSIS AND TESTING - CHECKING
ENGINE OIL PRESSURE
gauge assembly C-3292.
Check for a clogged oil pick-up screen or a pressure
relief valve stuck open.
DIAGNOSIS AND TESTING - ENGINE OIL LEAK
engine, particularly at the area of the suspected leak.
Fig. 25 Engine Oil Lubrication System
(1) Remove oil pressure sending unit and install
(2) Run engine until thermostat opens.
(3) Oil Pressure:
• Curb Idle–25 kPa (4 psi) minimum
• 3000 rpm–170 - 758 kPa (25 - 110 psi)
(4) If oil pressure is 0 at idle, shut off engine.
Begin with a thorough visual inspection of the
DR