Provision the T1 8-Port Line Module
This subsection details the following information:
• Provision the Timing Source
• Provision the Uplink Identifier
Provision the Timing Source
To provision the T1 8‐Port timing source, complete the following:
1. From the Provisioning menu, select EFM Setting , and press E
2. From the EFM Settings menu, select Timing , and press E
3. From the Timing menu, select LoopA Timing Source , and press E
4. From the LoopA Timing Source menu, select the required option, and press Enter.
5. From the Timing menu, select LoopB Timing Source , and press E
6. From the LoopB Timing Source menu, select the required option, and press Enter.
Provision the Uplink Identifier
The uplink identifier settings depend on if the Nodes are being connected by way of the EFM
card.
To set the uplink identifier for RT Node, complete the following:
1. From the Provisioning menu, select EFM Setting , and press E
2. From the EFM Setting menu, select Uplink Identifier , and press E
3. From the Uplink Identifier System menu, select Select EFM Group , and press E
4. From the Select EFM Group menu, enter the selected EFM group, and press E
65K510DEP08-1A
Appendix J, GigE Star Provisioning - Remote Terminal (RT) Provisioning
This menu contains the following options:
• Select DS1: This setting allows the entry of the DS1 timing source. The valid settings
are from 1–8.
• None: When selected, this option does not set the timing source to the DS1. Timing
defaults to the timing set in the GigE SM.
This menu contains the following options:
• Select DS1: This setting allows the entry of the DS1 timing source. The valid settings
are from 1–8.
• None: When selected, this option does not set the timing source to the DS1. Timing
defaults to the timing set in the GigE SM.
NTER
.
.
NTER
NTER
.
NTER
.
.
NTER
NTER
.
NTER
NTER
.
.
J-15