Delete An Existing User Account - ADTRAN Total Access 5000 Deployment Manual

NOTE
If no change to the password is required, steps 4 ‐ 5 are optional.
4. From the User Configuration prompt, type password , and press E
5. From the Password Entry prompt, type the new password for the user, and press E
NOTE
If no change to the privilege level is required, step 6 is optional.
6. From the User Configuration prompt, type privilege [admin|config|read-
7. From the User Configuration prompt, by performing one of the following commands:
8. Type end , and press E

Delete an Existing User Account

To delete an existing user account on the Total Access 5000, complete the following procedure:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type security , and press E
3. From the Security Configuration prompt, type no username WORD , and press E
4. Type end , and press E
65K510DEP08-1A
Password Entry prompt.
only|read-write|test]
• Type no disable , and press E
• Type disable , and press E
NTER
bal Configuration prompt.
Security Configuration prompt.
delete the account.
NTER
Section 3, Common Provisioning - Configure Local User Accounts
, and press E
NTER to set the user privilege level.
NTER to enable the username
NTER to disable the username
to return to the Enable prompt.
to return to the Enable prompt.
to access the
NTER
.
NTER
to access the Glo‐
NTER
to access the
NTER
to
NTER
3-25