Provision The Timing Source - ADTRAN Total Access 5000 Deployment Manual

Provision the Timing Source

To set the timing sources (primary and secondary) to BITS, complete the following procedure:
NOTE
The primary and secondary timing sources can be different depending on the
configuration.
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type system-timing <shelf> , and press E
NOTE
<shelf>
3. From the System Timing Configuration prompt, set the primary timing source to Ext A
4. From the System Timing Configuration prompt, set the secondary timing source to Ext B
5. Type end , and press E
65K510DEP08-1A
bal Configuration prompt.
to access the System Timing Configuration prompt.
is the node number of the shelf being provisioned, typically 1.
by typing source primary external primary , and press E
by typing source secondary external secondary , and press E
NTER
Section 3, Common Provisioning - Provision the Timing Source
to return to the Enable prompt.
NTER to access the Glo‐
NTER
NTER .
NTER .
3-13