Provision MAC Address Limiting and Aging
To prevent MAC Address storms at the customer Ethernet/Gigabit‐Ethernet ports, the
NetVanta 800 series supports MAC Address Limiting. The NetVanta learns MAC addresses
from traffic ingressing the customer interface; once the NetVanta learns the provisioned limit,
it does not allow any additional MAC addresses to pass toward the network. The MAC
Address limit can be set to any value from 1 to 100. MAC Address Limiting can also be
disabled. By default, the NetVanta limits the customer to 100 learned MAC Addresses.
If enabled, MAC Address aging can be used. By default, the MAC Aging timeout is 5
minutes. The MAC Aging Timeout can be set to any value from 1 to 3600 seconds. If set to
zero, MAC Aging is disabled, and learned MAC addresses are locked.
To set the MAC Address Limit count and aging values, complete the following steps:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, access the Ethernet Configuration prompt or the
3. Type mac limit <# of MAC addresses> , and press E
NOTE
To disable MAC limiting, type no mac limit , and press E
4. Type mac aging-time <timeout_value> , and press E
5. Type end , and press E
65K510DEP08-1A
Section 6, EoTDM Provisioning - Provision MAC Address Limiting and Aging
bal Configuration prompt.
Gigabit‐Ethernet Configuration prompt by completing one of the following:
• Type interface ethernet 1/0/port , and press E
Configuration prompt, where port is any value from 1 to 4
• Type interface gigabit-ethernet 1/0/1 , and press E
Ethernet Configuration prompt
of MAC Addresses allowed on the selected interface, from 1 to 100 addresses.
Aging Timeout value for the selected interface, where timeout_value is the new timeout
value in seconds, between 0 (MAC aging is disabled) and 3600 seconds.
NTER
to return to the Enable prompt.
NTER
to access the Glo‐
to access the Ethernet
NTER
to access the Gigabit‐
NTER
to set the maximum number
NTER
.
NTER
NTER
to set the MAC Address
6-27