5. From the PPP Group prompt, type peer default ip address A.B.C.D , and press
NOTE
A.B.C.D is the IP address of the subtended device.
6. From the PPP Group prompt, type peer default ip default-gateway A.B.C.D ,
NOTE
A.B.C.D is the IP address of the default gateway.
7. From the PPP Group prompt, type peer default ip dns A.B.C.D E.F.G.H , and
NOTE
A.B.C.D is the IP address of the primary DNS and E.F.G.H is the IP address of
the secondary DNS. Specifying the secondary DNS is optional.
8. From the PPP Group prompt, type no shutdown , and press E
9. From the PPP Group prompt, type end , and press E
10. From the Enable prompt, type show interfaces ppp-group <shelf/slot/group> ,
Delete a PPP Group
To delete a PPP group, complete the following steps:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type no interface ppp-group <shelf/
3. From the Global Configuration prompt, type end , and press E
65K510DEP08-1A
Enter to set the PPP group peer IP address.
and press E
NTER
to set the PPP group peer default gateway address.
press E
NTER
to set the PPP group peer DNS addresses.
group.
The PPP group is now created.
and press E
NTER
to view the PPP group configuration and status.
bal Configuration prompt.
, and press E
slot/group>
prompt.
Section 5, BSM Provisioning - Create a Point-To-Point Protocol Group
NTER
to delete the specified PPP group.
NTER
to activate the PPP
NTER
to return to the Enable prompt.
NTER
to access the Glo‐
NTER
to return to the Enable
5-9