Total Access 5000 Business Services Deployment Guide
9. Provision the port administration state by performing one of the following commands:
Provision the Network Ports
To configure the network port administration states, complete the following:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type interface gigabit-ethernet
3. Type no shutdown , and press E
4. Repeat steps 2 and 3 for each port being used.
Provision the Ethernet Star
To configure the Total Access 5000 for a Gigabit Ethernet Star, complete the following:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type interface gigabit-ethernet
3. From the Ethernet Interface Configuration prompt, type downlink , and press E
Provision for Redundancy
To provision for redundancy, complete the following:
NOTE
To make the GE 4‐Port Line Module in the odd slot as the active module,
provision it first.
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type redundancy <shelf/slot> . and press
3. From the Redundancy Configuration prompt, type no shutdown , and press E
NOTE
Redundancy is not fully enabled until the even slot is also In Service.
J-12
• Type no shutdown , and press E
• Type shutdown maintenance , and press E
Unassigned
• Type shutdown , and press E
bal Configuration prompt.
, and press E
<shelf/slot/port>
prompt.
bal Configuration prompt.
, and press E
<shelf/slot/port>
prompt.
The downlink command enables downstream tree networking on the selected interface.
bal Configuration prompt.
E
NTER
.
NTER
to take a port In Service
to take a port Out of Service,
NTER
NTER
to take a port Out of Service, Unassigned
NTER
to access the Ethernet Interface Configuration
NTER
to set the port to In Service.
NTER
to access the Ethernet Interface Configuration
to access the Glo‐
NTER
to access the Glo‐
NTER
NTER
.
NTER
to access the Glo‐
NTER
.
65K510DEP08-1A