Map Example - ADTRAN Total Access 5000 Deployment Manual

Total Access 5000 Business Services Deployment Guide
4. From the EVC‐Map Configuration prompt, enable the map by typing no shutdown , and
5. From the EVC‐Map Configuration prompt, type end , and press E
6. To save the changes to non‐volatile memory, type write , and press E
7. From the Enable prompt, view the new map by typing show evc-map WORD , and press

Map Example

The following is a sample output of the show interfaces map command for map‐2010.
6-22
dscp <0-63> . To remove this attribute from the match criteria, type no match
dscp . A range of DSCP values can be entered for this command.
f. L2CP: This configures the map to pass only layer 2 control protocol traffic. To
enable, type match l2cp . To remove this from the match criteria, type no match
l2cp .
press E
NTER .
Enable prompt.
E
.
NTER
This command also displays the EVC and UNI that the map is attached.
Once this process is completed, data can be run through the system. If untagged data is
sent into the NetVanta 800, the GigE SM Ethernet port transmits data tagged with the
appropriate S‐tag.
MyNV800#show evc-map my_test_map
Admin State
EVC-map Status
Connected EVC
Policer
Connected UNI
Match Traffic Type
Match Traffic Type
MyNV800#
: Enabled
: Running - Enabled
: evc2010
: None
: Ethernet 1/0/1
: Broadcast
: Multicast
to return to the
NTER
.
NTER
65K510DEP08-1A