NOTE
The privileged commands (Enable prompt) are designated by the # prompt.
Set the Date and Time
To set the date and time, complete the following:
1. From the Enable prompt, type config term , and press E
2. From the Global Configuration prompt, type clock set <HH:MM:SS> <1-31> WORD
3. Type exit , and press E
Provision the SNMP Interface
The SNMP interface is configured to provide almost all items accessible through the Total
Access 5000 CLI. Status and performance monitoring parameters are read‐only elements,
whereas configuration items are read‐write. The only items that may not be changed through
SNMP are network management elements that would interfere with proper operation of the
Ethernet or Inband interfaces, such as IP addresses, default routes, etc.
NOTE
The SNMP information is required in order for the Total Access EMS to
interface with the Total Access 5000.
To provision the SNMP information, complete the following:
1. From the Enable prompt, type config term and press E
2. From the Global Configuration prompt, type snmp-server host A.B.C.D , and press
3. From the Global Configuration prompt, type snmp-server chassis-id WORD to set
NOTE
The chassis name is entered using up to 55 alpha‐numeric characters
beginning with a letter character with no spaces allowed.
4. From the Global Configuration prompt, type snmp-server location WORD to set the
NOTE
The SNMP server location allows spaces, special characters, and upper and
lower case characters. The SNMP server location is limited to 55 alpha‐
numeric characters.
65K510DEP08-1A
, and press E
<2000-2036>
NTER
figuration prompt.
E
to add an SNMP server entry to the Total Access 5000.
NTER
the System Name, and press E
System Location to the desired location name, and press E
Section 3, Common Provisioning - Set the Date and Time
NTER
.
to return to the Enable prompt.
.
NTER
NTER
.
NTER
to access the Global Con‐
NTER
.
3-3