Total Access 5000 Business Services Deployment Guide
Provision the GigE SM
This section details the following information:
• Provision the GigE SM administration state
• Provision the network ports
• Provision the network port modes
• Provision the LACP switchover mode
• Provision for Link Aggregation Control Protocol (LACP)
• Provision the timing source
Provision the GigE SM Administration Status
For traffic to pass, the GigE SM module must be enabled.
Table 3‐2 displays the three administration states and the equivalent service states from prior
releases.
Command
no shutdown
shutdown maintenance
shutdown
To set the module administration state, complete the following procedure:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, provision the module administration state by
NOTE
• If connected to the shelf where the module resides, the shelf number is
typically 1.
• This is the slot of the module being configured. Valid values for the Switch
Modules are A and B .
3-6
Table 3-2. GigE SM Administration States
bal Configuration prompt.
entering one of the following commands:
• Type no slot shutdown <shelf/slot> , and press E
• Type slot shutdown maintenance <shelf/slot> , and press E
card Out of Service, Maintenance
• Type slot shutdown <shelf/slot> , and press E
Unassigned
Previous
Description
In Service
In the
and alarms are generated.
Out of Service,
In the
Maintenance
traffic passes but no alarms are generated.
Alarms are suppressed and no evidence of
the alarm is shown.
Out of Service,
In the
Unassigned
and no alarms are generated.
no shutdown
state, traffic passes
shutdown maintenance
shutdown
state, no traffic passes
NTER
to access the Glo‐
NTER
to take a card In Service
NTER
to take a
NTER
to take a card Out of Service,
65K510DEP08-1A
state,