Default Severities; T3 Alarm Severity Level; Table H-2. Default Severities - ADTRAN Total Access 5000 Deployment Manual

Total Access 5000 Business Services Deployment Guide
Introduction
Total Access System Release 4.5 allows the user to configure the alarm severity level for all T3
and T1 fault alarms, along with being able to enable or disable all alarms. The alarm severities
are provisioned on a per‐slot basis.

Default Severities

Table H‐2 displays the T3 and T1 alarms and their default severities.

T3 Alarm Severity Level

To set the alarm severity level for a T3 alarm, complete the following steps:
1. From the Enable prompt, type configure terminal , and press E
2. From the Global Configuration prompt, type interface t3 <shelf/slot/port> , and
3. From the T3 Configuration prompt, type alarm level <alarm_name>
4. From the T3 Configuration prompt, provision the alarm status by performing one of the
5. From the T3 Configuration prompt, type end , and press E
Table H‐3 displays the T3 Parameter Values.
H-2
Alarm
T3 Alarm Defaults
LOS
LOF
RAI
AIS
T1 Alarm Defaults
LOF
RAI
AIS
bal Configuration prompt.
press E
NTER to access the T3 Configuration prompt.
, and press E
<alarm_level>
valid alarm_name and alarm_level values.
following commands:
• Type no alarm enable <alarm_name> , and press E
alarm
• Type alarm enable <alarm_name> , and press E
prompt.

Table H-2. Default Severities

Default
Major
Major
Minor
Major
Major
Minor
Major
NTER to set the alarm severity level. Refer to Table E‐2 for
NTER to access the Glo‐
NTER to disable the specified
NTER to enable the specified alarm
NTER to return to the Enable
65K510DEP08-1A