Parameter Mode - Mitsubishi melservo-j2 series Instruction Manual

7. DISPLAY AND OPERATION

7.6 Parameter Mode

Change the parameter settings when:
• The regenerative brake option is used;
• The number of pulse per servo motor revolution is changed
• The machine mounted with the servo motor hunts or operational performance is further improved.
The parameter whose abbreviation is marked
changing its setting. (Refer to Section 5.2.1.)
(1) Operation example
1) 4-digit parameter
The following example shows the operation procedure performed after power-on to change the home
position setting method (Parameter No.8) into the data setting type.
To shift to the next parameter, press the "UP" or "DOWN" button.
When changing the parameter No.8 setting, change its set value, then switch power off once and
switch it on again to make the new value valid.
Press four times. Select parameter No.8 with
MODE
The parameter number is displayed.
Press or to change the number.
UP DOWN
Press twice.
SET
The set value of the specified parameter number flickers.
Press twice.
UP
During flickering, the set value can be changed.
Use or .
UP DOWN
(!!!2: Data setting type)
Press to enter.
SET
7 - 8
is made valid by switching power off, then on after
UP
or .
DOWN