8. COMMUNICATION FUNCTIONS
(11) Dwell time write
Write the dwell time of the point table.
Transmit command [C][A], any of data No. [0][1] to [0][F] corresponding to the point table to be
written to, and the data. Refer to Section 8.11.2.
Command
Data No.
[0][1] to
[C][A]
[0][F]
0
Hexadecimal data
Write mode
0: EEP-ROM, RAM write
1: RAM write
When the positioning address is changed frequently through
communication, set "1" to the write mode to change only the RAM data in
the servo amplifier.
If the EEP-ROM value is changed frequently, EEP-ROM fault will occur
due to the excess of the permissible EEP-ROM write times.
(12) Auxiliary function write
Write the auxiliary function of the point table.
Transmit command [C][B], any of data No. [0][1] to [0][F] corresponding to the point table to be
written to, and the data. Refer to Section 8.11.2.
Command
Data No.
[0][1] to
[C][B]
[0][F]
0
Hexadecimal data
Write mode
0: EEP-ROM, RAM write
1: RAM write
When the positioning address is changed frequently through
communication, set "1" to the write mode to change only the RAM data in
the servo amplifier.
If the EEP-ROM value is changed frequently, EEP-ROM fault will occur
due to the excess of the permissible EEP-ROM write times.
Data
See below.
Data
See below.
8 - 35