Pppoe Configuration; Pppoe Configuration - Lucom lr77 v2 Configuration Manual

3.4 PPPoE Configuration
PPPoE (Point-to-Point over Ethernet) is a network protocol which encapsulates PPPoE
frames into Ethernet frames. The router uses the PPPoE client to connect to devices support-
ing a PPPoE bridge or server. The bridge or server is typically an ADSL router.
To open the PPPoE Configuration page, select the PPPoE menu item. If you mark the
Create PPPoE connection check box, then the router attempts to establish a PPPoE connec-
tion after boot up. After connecting, the router obtains the IP address of the device to which
it is connected. The communications from a device behind the PPPoE server is forwarded to
the router.
Item
Username
Password
Authentication
MRU
MTU
Setting a bad packet size value (MRU, MTU) can cause unsuccessful transmission.
LUCOM GmbH * Ansbacher Str. 2a * 90513 Zirndorf * Tel. 09127/59 460-10 * Fax. 09127/59 460-20 * www.lucom.de
Description
Username for secure access to PPPoE
Password for secure access to PPPoE
Authentication protocol in GSM network
PAP or CHAP – The router selects the authentication method.
PAP – The router uses the PAP authentication method.
CHAP – The router uses the CHAP authentication method.
Specifies the Maximum Receiving Unit. The MRU identifies the max-
imum packet size, that the router can receive in a given environ-
ment. The default value is 1492 bytes. Other settings can cause in-
correct data transmission.
Specifies the Maximum Transmission Unit. The MTU identifies the
maximum packet size, that the router can transfer in a given envi-
ronment. The default value is 1492 bytes. Other settings can cause
incorrect data transmission.
Table 26: PPPoE configuration
Figure 24: PPPoE configuration
36
3. CONFIGURATION