Applying Standby Power To The Server; Lan - HP AB464-9003F Service Manual

Applying Standby Power to the Server

To apply standby power to the server, follow these steps:
1. Locate the appropriate receptacle on the rear of the chassis. Plug the power cord into the
receptacle.
IMPORTANT:
PWR 1.
2. Observe the following LEDs at two different intervals to ensure the server is in the standby
power state:
INTERVAL ONE
After you plug the power cord into the server, the BPS flashes amber and an amber light is
present on the hard disk drives.
INTERVAL TWO
Approximately 30 seconds later, the BPS flashes green and the amber light is still present
on the hard disk drives. Standby power is now on.

LAN

The server has two LAN ports that can provide network connectivity.
LAN ports for the server.
Figure 35 Rear Panel LAN Ports
If the server has one BPS, plug the power cable into the receptacle labeled
Figure 35 shows the available
Connecting the Cables 75