Replacing The Top Cover - HP AB464-9003F Service Manual

NOTE:
The memory carrier assembly cover can remain in place while servicing any components
except for the memory carrier assembly and the processor board assembly.
3. Slide the cover toward the rear of the server until the tabs release from the slots in the
chassis.
4. Lift the cover off the chassis.
Figure 17 Removing and Replacing the Top Cover

Replacing the Top Cover

NOTE: Always replace the memory carrier assembly cover before replacing the top cover.
To replace the top cover, follow these steps:
1. Ensure the memory carrier assembly cover is in place.
2. Ensure the cover release lever is in the unlocked position
3. Align the tabs of the top cover with the corresponding slots in the chassis. Insert the tabs
into the slots.
4. Slide the cover forward until it is flush with the front of the chassis.
5. Push the cover release lever down into the latched position
6. Lock the cover release lever. Turn the cam 90 degrees clockwise.
46 Installing the System
The cover release lever also disengages the memory carrier assembly cover.
(Figure 17).
(Figure 17).