Attaching The Hook-And-Loop Strap To The Bulk Power Supply And Power Cord; Applying Standby Power To The Server - HP Integrity rx6600 Installation Manual

the iLO 2 MP PC command, or the Power button is activated. In the off state, the power cords are
not plugged in.
Table 8 lists the server power states.
Table 8 Power States
Power States
Standby power
Full power
Off
NOTE: If the power restore feature is set to Always On through the iLO 2 MP PR command, the
server can automatically power on to the full power state.

Attaching the Hook-and-Loop Strap to the Bulk Power Supply and Power Cord

CAUTION:
cord, the power cord might pop off the back.
To attach the hook-and-loop strap to the bulk power supplies and power cord, follow these steps:
1. Attach the hook-and-loop strap to the handle on the bulk power supply.
2. Attach the other end of the strap to the power cord
Figure 18 Fastening the Power Supply

Applying Standby Power to the Server

To apply standby power to the server, follow these steps:
40 Installing the System
Power Cable Power Activated through the iLO 2 MP PC
Plugged Into Command or Front Panel Power Button
Receptacle Activated
Yes No
Yes Yes
No No
If you do not fasten the hook-and-loop strap to the bulk power supply and the power
AC Voltage
Applied
Yes
Yes
No
(Figure 18).
DC Voltage
Applied
No
Yes
No