Specifying Scsi Parameters; Using The Scsi Setup Utility - HP AB464-9003F Service Manual

Example 25 sysmode command
Shell> sysmode
System Mode: NORMAL
Shell> sysmode admin
You are now in admin mode.
Shell> sysmode service
You are now in service mode.
Shell> sysmode normal
You are now in normal mode

Specifying SCSI Parameters

The following SCSI parameters can be configured for the SCSI board:
SCSI ID (SCSI initiator ID)
Maximum data transfer rate (SCSI rate)
Bus width
Whether the HBA is bootable (driver support)
Avoid bus resets (secondary cluster server)

Using the SCSI Setup Utility

To use the SCSI Setup Utility to specify SCSI parameters, follow these steps:
Specifying SCSI Parameters 335