Installing System Memory Dimms - HP AB464-9003F Service Manual

3. Slide the memory carrier assembly into the chassis until it begins to seat into the socket
located on the processor board.
CAUTION:
the memory carrier assembly into the socket on the processor board. Manipulate the
extraction handles with care; failure to observe these cautions can result in damage to the
extraction handles and other server components.
4. Rotate the extraction handles inward and press the handles straight down until they snap
into the locked position.
5. Replace the memory carrier assembly cover and latch the top cover release lever. See
"Removing and Replacing the Memory Carrier Assembly Cover" (page

Installing System Memory DIMMs

System memory DIMMs are located on a pair of memory boards inside the memory carrier
assembly.
WARNING!
disconnected from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
follow ESD safety precautions can result in damage to the server.
Figure 25 shows the memory carrier assembly removed from the chassis.
Do not apply excessive force when closing the extraction handles and seating
Ensure that the system is powered off and all power sources have been
Observe all ESD safety precautions before attempting this procedure. Failure to
47).
Installing Additional Components 57