Replacing The Tpm - HP AB464-9003F Service Manual

Figure 80 TPM Location on I/O Board
Core I/O Board Slot
1
I/O VRM
2

Replacing the TPM

To replace the TPM, follow these steps:
1. Insert the TPM.
a. Align the TPM connector pinouts with the pins on the I/O board socket.
NOTE:
a missing pin on the male connector on the I/O board assembly.
b. Push the TPM straight down into the socket until it is fully seated
2. Replace the core I/O board. See
3. Replace the top cover. See
4. If rack installed, slide the server completely into the rack. See
Rack" (page
5. Reconnect the power cables and power on the server. See
(page 89).
6. Set the TPM to the prior state, if available, or to a customer preference.
example of using the secconfig command to enable the TPM.
Example 1 Enabling the TPM
1. Access the EFI Shell.
2. Enter info sec to display the server security settings on the screen. The TPM is
disabled by default.
3. Enter secconfig to display a list of configurable security settings.
4. Enter secconfig tpm on to enable the TPM.
7. Reset the server.
8. Boot the operating system. See
TPM
3
The female connector on the TPM has one pinout plugged, which aligns with
"Replacing the Core I/O Board" (page
"Replacing the Top Cover" (page
177).
"Booting and Shutting Down HP-UX" (page
System Battery
4
179).
"Inserting the Server into the
"Powering On the Server"
Removing and Replacing the Trusted Platform Module 233
(Figure 80).
235).
Example 1 is an
119).