HP AB464-9003F Service Manual page 193

card. This section describes the following hot-plug operations and PCI/PCI-X/PCIe card
replacement procedures:
"PCI/PCI-X/PCIe Configurations"
Describes PCI/PCI-X/PCIe capabilities and relates card functions and capabilities to specific
slots.
"Online Addition (OLA)"
Describes the installation of new PCI/PCI-X/PCIe expansion cards in previously empty slots
without powering down the server.
"Online Replacement (OLR)"
Describes the replacement of a PCI/PCI-X/PCIe card without powering down the server.
This action requires suspending the associated driver. The existing driver for the old card
must be compatible with the new card.
CAUTION: If you are performing OLR on HP-UX 11i version 1 (and later), the card you
install must be exactly the same as the card you replace. This is also known as like-for-like
replacement.
"Removing a PCI/PCI-X/PCIe Card Offline"
Describes the removal of a PCI/PCI-X/PCIe card after powering down the server.
"Installing a PCI/PCI-X/PCIe Card Offline"
Describes the installation of a PCI/PCI-X/PCIe card after powering down the server.
Figure 65 shows the PCI/PCI-X/PCIe slot identification and card divider locations.
NOTE: Slots one through eight are full-length; slots nine and ten are short-length.
Removing and Replacing a Hot-Pluggable PCI/PCI-X/PCIe Card 193