HP AB464-9003F Service Manual page 337

Using the SCSI interface information from this example, the combined information that tells
you this is a SCSI interface are the following (shown in bold, for highlighting purposes):
00 20 01
00 20 01
The vendor (0x1000) and device (0x0030) are the IDs for a SCSI interface. Of the devices
with those IDs, this device has two channels (Fnc # of 00 followed by Fnc # of 01). Also, this
SCSI interface has a non-numeric (XX) slot # indicating that it is on the system board.
2. From the EFI Shell prompt, enter the following command to obtain the controller's handle
for the SCSI interface:
Shell> devtree
A tree of all EFI-capable devices installed in the system displays. For example:
Shell> devtree
Device Tree
Ctrl[04]
Ctrl[0A] Acpi(HWP0002,0)
Ctrl[12] Usb Open Host Controller
Ctrl[13] Usb Open Host Controller
Ctrl[14] Acpi(HWP0002,0)/Pci(1│2)
Ctrl[15] PCI IDE/ATAPI Controller
Ctrl[48] DW-28E
Ctrl[83] FAT File System [FAT32] 118 MB
Ctrl[16] Acpi(HWP0002,0)/Pci(3|0)
Ctrl[49] Acpi(HWP0002,0)/Pci(3|0)/Mac(00306E4C4F1A)
Ctrl[0B] Acpi(HWP0002,100)
Ctrl[17] LSI Logic Ultra320 SCSI Controller
Ctrl[18] LSI Logic Ultra320 SCSI Controller
Ctrl[19] Acpi(HWP0002,100)/Pci(2|0)
Ctrl[4B] Broadcom NetXtreme Gigabit Ethernet (BCM5701)
Ctrl[0C] Acpi(HWP0002,200)
Ctrl[0D] Acpi(HWP0002,400)
Ctrl[0E] Acpi(HWP0002,700)
Ctrl[1A] Acpi(HWP0002,700)/Pci(1|0)
Ctrl[1B] Acpi(HWP0002,700)/Pci(1|1)
Ctrl[36] 16550 Serial UART Driver
Ctrl[37] VT-100+ Serial Console
Ctrl[31] Primary Console Input Device
00 0x1000 0x0030
01 0x1000 0x0030
xx Acpi(HWP0002,200)/Pci(1|0)
xx Acpi(HWP0002,200)/Pci(1|1)
Specifying SCSI Parameters 337