Replacing The Memory Carrier Assembly - HP AB464-9003F Service Manual

Figure 67 Removing and Replacing the Memory Carrier Assembly

Replacing the Memory Carrier Assembly

CAUTION:
carrier assembly. The processor board assembly access door must be flush with the front bezel.
To replace the memory carrier assembly, follow these steps:
1. Ensure that the extraction handles are positioned in the outward, unlocked position.
2. Align the memory carrier assembly with the front and rear chassis guide slots.
NOTE:
the front of the chassis.
3. Slide the memory carrier assembly into the chassis until it begins to seat into the socket
located on the processor board.
CAUTION:
the memory carrier assembly into the socket on the processor board. Manipulate the
extraction handles with care; failure to observe these cautions can result in damage to the
extraction handles and other server components.
4. Rotate the extraction handles inward and press the handles straight down until they snap
into the locked position.
5. Replace the memory carrier assembly cover and latch the top cover release lever closed.
See "Replacing the Memory Carrier Assembly Cover" (page
Ensure the processor board assembly is fully seated before you replace the memory
Assembly side 0 is on the left, and assembly side 1 is on the right as viewed from
Do not apply excessive force when closing the extraction handles and seating
180).
Removing and Replacing the Memory Carrier Assembly 205