Determining The Ilo 2 Mp Lan Configuration Method - HP AB464-9003F Service Manual

Figure 37 Server Rear Ports
iLO 2 MP RS-232 Serial
1
Port (DB-9F to DB-9F cable)
Connected to emulation
terminal device (PC, laptop,
or ASCII terminal)
General Use Serial Port
2
(Printers, etc.)
Use Table 30
connection method, required connection components, and connectors to the host console.
Table 30 Physical Connection Matrix
Connection Method
RS-232 serial port
LAN port

Determining the iLO 2 MP LAN Configuration Method

To access the iLO 2 MP through the iLO 2 MP LAN, the iLO 2 MP must acquire an IP address.
The way the iLO 2 MP acquires an IP address is dependent upon whether DHCP is enabled or
disabled on the server, and if DHCP and DNS services are available to the server. (See
for possible scenarios.)
USB 2.0 Ports
3
(any USB device)
iLO 2 MP LAN Port
4
(10/100 LAN)
to determine your physical connection method.
Required Connection Components
1. Host console
2. RS-232 serial port DB-9F to DB-9F cable
3. Emulation terminal device (for example, a PC, laptop, or ASCII terminal)
10/100 LAN cable
VGA Port
5
No iLO 2 MP access; EFI
only
Table 30 lists the appropriate
Console Setup
Table 31
79