Attaching The Hook-And-Loop Strap To The Bulk Power Supply And Power Cord - HP AB464-9003F Service Manual

Plug the power cord into the appropriate receptacle on the rear of the chassis to achieve the
standby power state; the front panel Power button is not turned on. Full power occurs when the
power cord is plugged into the appropriate receptacle, and either the power is activated through
the iLO 2 MP PC command, or the Power button is activated. In the off state, the power cords
are not plugged in.
Table 27 lists the server power states.
Table 27 Power States
Power States
Standby power
Full power
Off
NOTE: If the power restore feature is set to Always On through the iLO 2 MP PR command,
the server can automatically power on to the full power state.

Attaching the Hook-and-Loop Strap to the Bulk Power Supply and Power Cord

CAUTION:
cord, the power cord might pop off the back.
To attach the hook-and-loop strap to the bulk power supplies and power cord, follow these steps:
1. Attach the hook-and-loop strap to the handle on the bulk power supply.
2. Attach the other end of the strap to the power cord
Figure 34 Fastening the Power Supply
74 Installing the System
Power Cable Power Activated through the iLO 2 MP
Plugged Into PC Command or Front Panel Power
Receptacle
Button Activated
Yes No
Yes Yes
No No
If you do not fasten the hook-and-loop strap to the bulk power supply and the power
AC Voltage
Applied
Yes
Yes
No
(Figure 34).
DC Voltage
Applied
No
Yes
No