Removing The Memory Carrier Assembly - HP AB464-9003F Service Manual

WARNING!
disconnected from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
follow ESD safety precautions can result in damage to the server.

Removing the Memory Carrier Assembly

To remove the memory carrier assembly, follow these steps:
1. Power off the server and disconnect the power cables. See
(page 89).
2. If rack installed, slide the server out from the rack until it stops. See
from the Rack" (page
3. Unlatch the cover release lever on the top cover and remove the memory carrier assembly
cover. See
NOTE:
the top cover release lever must be open.
4. Press the button located in the center of the memory carrier assembly to release the extraction
handles
CAUTION:
can result in damage to the extraction handles.
5. Pull up on the extraction handles, and rotate them outward approximately 90 degrees
(Figure 67).
NOTE:
6. Pull the extraction handles to lift the memory carrier assembly out of the chassis
NOTE:
recommends rotating the handles inward and snapping them into the locked position when
servicing the system DIMMs or any time the carrier is out of the chassis. Before replacing
the memory carrier assembly, press the button to release the extraction handles. Use the
handles to replace the memory carrier into the chassis.
204 Removing and Replacing Server Components
Ensure that the system is powered off and all power sources have been
Observe all ESD safety precautions before attempting this procedure. Failure to
176).
"Removing the Memory Carrier Assembly Cover" (page
You do not need to fully remove the top cover to service this component; however,
(Figure 67).
Manipulate the extraction handles with care; failure to observe this caution
The extraction handles latch into the open position with an audible click.
To avoid damage to the extraction handles, Hewlett Packard Enterprise
"Powering Off the Server"
"Extending the Server
179).
(Figure 67).