Table of Contents
Advertisement
NOTE:
To identify each item by part number, refer to the sales order packing slip.
Returning Damaged Equipment
If the equipment is damaged, contact your Hewlett Packard Enterprise customer service
representative immediately. The service representative initiates appropriate action through the
transport carrier or the factory and assists you in returning the equipment.
Unloading the Server with a Lifter
WARNING!
center the server on the lifter forks before lifting it off the pallet to avoid injury.
NOTE:
Hewlett Packard Enterprise recommends that you follow local guidelines when lifting
equipment.
To unload the server from the pallet using a lifter, follow these steps:
1.
Unpack the server.
2.
Unroll the bottom corrugated tray on the side where you will place the lifter, and slide the
server as close to that edge of the pallet as possible.
3.
Break off any foam packaging that can prevent you from fully inserting the lifter under the
server.
IMPORTANT:
foam is required to elevate the server and enable the forks of the lifter to be inserted under
the server.
4.
Insert the lifter forks under the server.
5.
Roll the lifter forward carefully until it is positioned against the side of the server.
6.
Raise the server slowly off the pallet until it clears the pallet cushions.
7.
Roll the lifter and server away from the pallet. Do not raise the server any higher than
necessary when moving it to the rack.
Installing Additional Components
This section describes how to install components into the server that are not factory integrated.
Most servers are preconfigured with all components installed prior to shipping from the Hewlett
Packard Enterprise factory. If you do not have additional components to install, you can skip this
chapter and install the server.
Removing and Replacing the Top Cover
NOTE:
When the top cover is open or removed, the chassis fan units increase to high speed
to assist cooling. When the top cover is replaced at the end of the operation, the chassis fans
return to normal speed.
Removing the Top Cover
To remove the top cover, follow these steps:
1.
Unlock the cover release lever
2.
Pull up on the cover release lever to disengage the top cover from the chassis
Use caution when using a lifter. Because of the weight of the server, you must
Do not remove the foam packaging from the corners of the server. This
(Figure
17). Turn the cam 90 degrees counterclockwise.
Installing Additional Components
(Figure
17).
45
Advertisement
Table of Contents
Troubleshooting
