Powering Off And Powering On The Server; Server Power Button; Power States - HP AB464-9003F Service Manual

2. Connect the cables. See your user service guide for specific port information.
a. Connect the monitor VGA cable to the appropriate VGA port on your server.
b. Connect the keyboard USB cable to the appropriate USB port on your server.
c. Connect the mouse USB cable to the appropriate USB port on your server.
3. Power on the server. The EFI Shell prompt displays.

Powering Off and Powering On the Server

This section provides information and procedures for powering off and powering on the server.
For more information, see the operating system documentation.

Server Power Button

Figure 40 shows the server Power button.
Figure 40 Server Power Button

Power States

The server has three power states:
Standby power
Full power
Off
Table 33 lists the server power states.
88 Installing the System
Plug the power cord into the appropriate receptacle on the rear of the
chassis; the front panel Power button is not turned on.
Full power occurs when you plug the power cord into the appropriate
receptacle, and either activate the power using the iLO 2 MP PC command,
or press the Power button.
Unplug the power cords.