Error Codes - Leroy-Somer digitax st User Manual

14.4

Error codes

Table 14.5 SM-PROFIBUS DP-V1 error codes
Error code
0
52
61
65
66
70
71
74
80
81
82
83
97
98
99
98
Fault
No error detected
User control word trip
Configuration error
Network loss
Critical link failure
FLASH transfer error
Invalid fieldbus specific
data
SM-PROFIBUS DP-V1
overtemperature
Inter-option
communication error
Communication error to
slot 1
Communication error to
slot 2
Communication error to
slot 3
Firmware incompatible
Internal watchdog error
Internal software error
www.leroy-somer.com
Description
Indicates that the SM-PROFIBUS DP-V1 module is
healthy. It is possible to trip the drive externally via various
communication channels.
The TRIP bit has been set in the drive control word.
An invalid module configuration has been detected. Refer
to Pr MM.49 for mapping error codes.
No new messages have been received for the specified
network loss trip time.
Internal error
The SM-PROFIBUS DP-V1 was unable to upload the
configuration parameters from its flash memory to the
drive.
SM-PROFIBUS DP-V1 has detected an invalid data
record. E.g. the stored I&M data has an invalid checksum.
If the temperature inside the SM-PROFIBUS DP-V1
°
module exceeds 82 C, SM-PROFIBUS DP-V1 will trip the
drive.
An inter-option communication time-out has occurred, but
SM-PROFIBUS DP-V1 is unable to determine the reason
for the error.
Communications between the SM-PROFIBUS DP-V1
module and an SM-Applications module in another slot
has timed out.
The hardware revision level does not support the installed
firmware version.
If DP-V1 functionality is required then replace the module
with a DP-V1 compatible module. If DP-V1 functionality is
not required then install an earlier firmware version
(03.01.01 or earlier).
Internal error. Cycle power to the drive to reset from this
trip. If trip persists, replace the SM-PROFIBUS DP-V1.
SM-PROFIBUS DP-V1 User Guide
Issue : a