Profidrive Status Word - Leroy-Somer digitax st User Manual

11.10

PROFIdrive status word

Table 11.6 gives the description of each bit in the PROFIdrive status word.
Table 11.6 PROFIdrive status word bit functions
Bit Value
1
0
0
1
1
0
1
2
0
1
3
0
1
4
0
1
5
0
1
6
0
1
7
0
1
8
0
1
9
0
1
10
0
11-15 0
SM-PROFIBUS DP-V1 User Guide
Issue : a
Function Comments
Ready to switch on Power supply switched on, the drive is inhibited.
Not ready to switch
Power supply switched off.
on
Ready To Operate Drive is ready to run.
Not Ready To
Drive is not ready to run.
Operate
Operation Enabled Drive is operational.
Operation Disabled Drive is not operational.
Drive faulted, and thus not operational, goes into the
Fault Present switch-on inhibit status after acknowledgment and the fault
has been removed. Fault number in the fault parameter.
No Fault Present Drive Healthy
Coast Stop Not
Coast Stop command is not active.
Activated
Coast Stop Activated Coast Stop command is active.
Quick Stop Not
Quick Stop command is not active.
Activated
Quick Stop Activated Quick Stop command is active.
Switch-on Inhibited Power supply switched on, the drive is inhibited.
Switch-on Not
Power supply switched on,
Inhibited
Warning Present Not Implemented
No Warning Present Not Implemented
Speed Error Within
'At Speed' (Pr 10.06) = 1
Tolerance
Speed Error Out Of
'At Speed' (Pr 10.06) = 0
Tolerance
Control Requested The automation system is requested to accept control.
No Control
Control only possible on the device itself.
Requested
Speed Or Frequency 'At Speed' (Pr 10.06) = 1 or
Reached/Exceeded 'Above Set Speed' (Pr 10.07) = 1
Speed Or Frequency 'At Speed' (Pr 10.06) = 0 and
Not Reached 'Above Set Speed' (Pr 10.07) = 0
Reserved
www.leroy-somer.com
69