Leroy-Somer digitax st User Manual page 95

Table 14.1 SM-PROFIBUS DP-V1 parameter reference
Menu
Pr MM.32
Pr MM.33
Pr MM.34
Pr MM.35
Pr MM.38
Pr MM.39
Pr MM.40
Pr MM.41
Pr MM.49
Pr MM.50
Pr MM.51
Table 14.2 SM-PROFIBUS DP-V1 virtual parameter reference
Parameter
Pr 61.01
Pr 61.20*
Pr 61.21*
Pr 61.35
Pr 61.40*
Pr 61.41*
Pr 61.42*
Pr 61.43*
Pr 61.50
Pr 61.51
* Not applicable to Digidrive SK.
Some drive firmware versions will hide unused or reserved parameters.
NOTE
SM-PROFIBUS DP-V1 User Guide
Issue : a
Default Cross reference Description
Section 5.8 on
0
page 20
Section 12.11 on
0
page 81
Section 12.5 on
0
page 75
Section 10.10 on
----
page 59
Section 13.2 on
0
page 86
4
Section 12.8 on
page 79
4
Section 13.1 on
0
page 85
Section 10.7 on
----
page 56
Section 10.9 on
----
page 58
Section 10.2 on
----
page 53
Default Cross reference Description
---- ----
---- ----
---- ----
Section 10.10 on
----
page 59
0
0
Section 12.14 on
page 83
0
0
Section 8.6 on
0
page 32
Section 8.8 on
0
page 42
www.leroy-somer.com
Re-initialize SM-PROFIBUS DP-V1. This will
automatically change back to 0 after re-
initialisation.
Restore the previous parameter configuration
from SM-PROFIBUS DP-V1 flash memory.
Cyclic data compression enable.
Serial Number.
PPO selected.
IN cyclic data words.
OUT cyclic data words.
SM-PROFIBUS DP-V1 Network compatibility
mode
Mapping status.
SM-PROFIBUS DP-V1 error codes.
Minor firmware version.
Parameter Pr 01.00 shortcut.
Coarse and turns position feedback.
Turns and fine position feedback.
Serial number.
SM-Applications event task trigger (lowest slot).
SM-Applications event task trigger (slot 1).
SM-Applications event task trigger (slot 2).
SM-Applications event task trigger (slot 3).
CT single word (Mode 1) non-cyclic data
mapping parameter.
PPO 4 Word (Mode 2) non-cyclic data mapping
parameter.
95