Profibus-Dp Node Address; Network Data Rate - Leroy-Somer digitax st User Manual

The software version takes the form of xx.yy.zz, where Pr 15.02 or Pr 16.02 displays
xx.yy and Pr 15.51 or Pr 16.51 displays zz (e.g. for software version 01.01.00 on a
module in the middle Solutions Module slot (Unidrive ES and Affinity) or for Unidrive
SPz and Digitax ST, the Solutions Module slot nearest the incoming supply terminals),
Pr 16.02 will display 1.01 and Pr 16.51 will display 0).
Digidrive SK (Sizes B to D and 2 to 6)
The software version of the Solutions Module can be identified by looking at Pr 15.02
and Pr 15.51. The software version takes the form of xx.yy.zz, where Pr 15.02 displays
xx.yy and Pr 15.51 displays zz (e.g. for software version 01.01.00 Pr 15.02 will display
1.01 and Pr 15.51 will display 0).
The full version of the SM-PROFIBUS DP-V1 firmware can be assembled by combining
the major version (xx.yy) and the minor version (zz) as follows: xx.yy.zz.
10.3

PROFIBUS-DP node address

Table 10.4 PROFIBUS-DP
Pr MM.03
Each node on a PROFIBUS-DP network must be given a unique network node address.
The SM-PROFIBUS DP-V1 must be re-initialized to make a change of node address
active. Addresses 0 and 126 are reserved for system use and should not be used.
10.4

Network data rate

Table 10.5
Pr MM.04
The SM-PROFIBUS DP-V1 will automatically detect the PROFIBUS-DP network data
rate and synchronise to it. Pr MM.04 will indicate the data rate that has been detected
by the SM-PROFIBUS DP-V1.
A value of -1 indicates that the SM-PROFIBUS DP-V1 has not detected any activity on
the PROFIBUS-DP network and is waiting for the master controller to start
communicating.
The PROFIBUS-DP data rate parameter can be changed, but this will not affect the data
NOTE
rate at which the SM-PROFIBUS DP-V1 communicates. The data rate display will be
updated when SM-PROFIBUS DP-V1 is re-initialized.
54
node address
Default
Range
Access
Network data rate
Default
Range
Access
www.leroy-somer.com
126
0 to 126
RW
N/A
-1 to 9
RO
SM-PROFIBUS DP-V1 User Guide
Issue : a