Table of Contents
Advertisement
3
Mechanical installation
Before installing or removing a Solutions Module in any drive, ensure the AC supply has
been disconnected for at least 10 minutes and refer to Chapter 1 on page 6. If using a
DC bus supply ensure this is fully discharged before working on any drive or Solutions
Module.
WARNING
3.1
General Installation
The installation of a Solutions Module is illustrated in Figure 3-1.
Figure 3-1 Fitting a Solutions Module
The Solutions Module connector is located on the underside of the module (1). Push
this into the Solutions Module slot located on the drive until it clicks into place (2). Note
that some drives require a protective tab to be removed from the Solutions Module slot.
For further information, refer to the appropriate drive manual.
12
2
www.leroy-somer.com
SM-PROFIBUS-DP User Guide
1
Issue : a
Hide quick links:
Advertisement
Table of Contents
