Connecting The Power Supply; Safety Rules; Wiring The Power Supply - Siemens SIMOTION D410-2DP/PN Installation Manual

4.4

Connecting the power supply

4.4.1

Safety rules

Because of the wide range of possible applications, only the basic rules for electrical installation
are described in this section. At a minimum, you must comply with these basic rules to ensure
problem-free operation.
Rules for safe operation
In order to ensure safe operation of your equipment, implement the following measures and
adapt them to suit your particular conditions:
● An EMERGENCY-OFF concept based on applicable technical specifications
(e.g. European Standards EN 60204, EN 418 and associated standards).
● Additional measures to limit the travel of axes
(e.g. hardware limit switch).
● Equipment and measures to protect motors and power electronics according to the
SINAMICS Installation Guidelines.
In order to identify hazards, we also recommend that a risk analysis be conducted on the entire
system in accordance with the basic safety requirements set out in Appendix 1 of the EU
machinery directive.
Additional references
● Guidelines on Handling Electrostatic Sensitive Devices (ESD), see Appendix ESD
guidelines (Page 327) in this manual.
● For installing a system with SIMATIC ET 200 I/O (e.g. ET 200S, ET 200M, etc.), see the
manuals for the relevant ET 200 I/O systems.
● For further information on EMC, we recommend the configuration manual
Guidelines / Basic System Requirementsn , article number 6FC5297-0AD30-0AP3.
Standards and regulations
You must comply with the applicable VDE guidelines when wiring the SIMOTION D410‑2, in
particular VDE 0100 and VDE 0113 for disconnecting devices, short-circuit and overload
protection.
4.4.2

Wiring the power supply

If no digital outputs are used or if the SIMOTION D410‑2 is being operated on a mounting
plate, the SIMOTION D410-2 can be supplied by the Power Module via the PM-IF interface.
SIMOTION D410-2
Commissioning and Hardware Installation Manual, 01/2015
Connecting
4.4 Connecting the power supply
EMC Installation
55