Carburetor Idle Speed; Radiator Coolant - Honda V 45 SABRE-VF750S 1982 Shop Manual

-
W HONDA
~ V45 ~~:::
Synchronize to specification by loosening the
adjusting screw lock nuts and turning the adjusting
screws with the following tools:
To adjust the No.2, 4 carburetor -
Carburetor adjusting wrench (07908-4220201)
To adjust the NO.3 carburetor -
Carburetor throttle adjusting bit (07908-
MBOOOOOI
or
(KS-AH-008-MBO, USA onlyl
and Adjusting wrench (07708-0030200) or
Snap-On Tool Wrench X0810 or equivalent
available in U.S.A.
Recheck the idle speed and synchronization.
Remove the gauge adapters and install the plugs.
Remove Ihe clip from Ihe automatic fuel valve
vacuum tube. Reconnect the tube to the No. 1
cylinder.
CARBURETOR IDLE SPEED
NOTE
• Inspect and adjust idle speed after all other
engine adjustments are within spe<:ifications .
• The engine must be warm for accurate adjust-
ment. Ten minutes of stop·and.go riding is
sufficient.
~------------~
Warm up the engine, shift to NEUTRAL, end plaC1l
the motorcycle on its center stand.
Turn the throttle stop screw as required to obtain
tne
specified idle speed.
IDLE SPEED: 1,000 ± 100 rpm
RADIATOR COOLANT
Remove the frame left side cover (V45 SABREl
Remove the frame right side cover
(V45
MAGNAI.
Check tha coolant lavel of the reserve tank with the
engine runing at normal operating temperature.
The level should ba between the "FULL" and
"LOW" ievellines.
If necessary, remove the reserve tank cap and fill to
the "FULL" level line with a
50/50
mixture of
distilled water and anti·freeze.
Reinstall the
cap
and frame side cover.
Date of Issue : October, 1982
©
HONDA MOTOR
CO"
LTD .
---
-
MAINTENANCE
CARBURETOR ADJUSTING
LOCK NUT
n!
. i~.'i'
39
3-13